Table of Contents
Advertisement
Suunto EON Steel
During a rebreather dive, you can also switch to a custom setpoint at any time.
To change to a custom setpoint:
1. While diving in CCR mode, keep middle button pressed to enter main menu.
2. Scroll to Custom setpoint and select with the middle button.
3. Adjust the setpoint value as needed with the lower or upper button and accept with the
middle button.
A popup notification confirms the custom setpoint switch.
NOTE: When you change to a custom setpoint, the automatic setpoint switching is
turned off for the remainder of the dive.
3.25.4. Bailouts
If at any point during a rebreather dive you suspect a malfunction of any sort, you should
switch to a bailout gas and abort the dive.
To change to a bailout gas:
1. Keep the middle button pressed to enter main menu.
2. Scroll to OC gases and select with middle button.
3. Scroll to the desired bailout gas and select with the middle button.
After a bailout gas is selected, the setpoint field is replaced with the pO
value of the selected
2
open-circuit gas.
If the malfunction is rectified or the dive situation otherwise normalizes, you can switch back
to a diluent using the same procedure as below, but selecting from CC gases.
3.26. Safety stops and deepstops
A three (3) minute safety stop is always recommended for every dive over 10 meters (19.7 ft).
The time for a safety stop is calculated when you are between 2.4 and 6 m (7.9 and 19.7 ft).
This is presented with up/down arrows in front of the stop depth. The safety stop time is
shown in minutes and seconds. The time may exceed three (3) minutes if you ascend too fast
during dive.
29
Advertisement
Table of Contents
