Sony XDS-PD1000C Operation Manual page 21

Analog video inputs
REF. VIDEO INPUT
BNC type (2) (loop-through), HD Tri-
level sync (0.6 Vp-p, 75 Ω, sync
negative), or SD black burst, SD
composite sync (0.286 Vp-p, 75 Ω,
sync negative)
Analog audio inputs
ANALOG AUDIO INPUT 1, 2
XLR 3-pin (2) female, +4 dBu, high
impedance, balanced
Digital audio inputs
DIGITAL AUDIO (AES/EBU) IN 1/2, 3/4, 5/6, 7/8
BNC type (4), channels 1/2, 3/4, 5/6, 7/8,
complying with AES-3id-1995
Timecode inputs
TIME CODE IN
BNC type (1), SMPTE timecode, 0.5 to
18 Vp-p, 3.3 kΩ, unbalanced
SYSTEM TC INPUT
BNC type (1), SMPTE timecode, 0.5 to
18 Vp-p, 3.3 kΩ, unbalanced
Output connectors
Digital video outputs
HD-SDI OUTPUT1 1, 2 (SUPER)
BNC type (2), complying with SMPTE
ST 292-1
SD-SDI OUTPUT1 1, 2 (SUPER)
BNC type (2), complying with SMPTE
ST 259
HD-SDI MONITOR/OUTPUT2 1, 2 (SUPER)
BNC type (2), complying with SMPTE
ST 292-1
SD-SDI MONITOR/OUTPUT2 1, 2 (SUPER)
BNC type (2), complying with SMPTE
ST 259
HDMI OUTPUT
Type A 19-pin (1), HDMI version 1.1
MONITOR (VGA)
DE-15 (1), complying with VGA
standards
1)
DVB-ASI OUTPUT
BNC (1)
1) When the optional PDBK-202 is installed.
Analog video outputs
COMPOSITE OUTPUT 1, MONI/2
BNC type (2), 1.0 Vp-p, 75 Ω, sync
negative, complying with SMPTE ST
170
Analog audio outputs
ANALOG AUDIO OUTPUT1 1, 2
XLR 3-pin (2) male, +4 dBu, 600 Ω load,
low impedance, balanced
ANALOG AUDIO MONITOR/OUTPUT2 R/1, L/2
XLR 3-pin (2) male, +4 dBu, 600 Ω load,
low impedance, balanced
PHONES Stereo phone jack (1), –∞ to –13 dBu,
8 Ω, unbalanced
Digital audio outputs
DIGITAL AUDIO (AES/EBU) OUT 1/2, 3/4, 5/6, 7/8
BNC type (4), channels 1/2, 3/4, 5/6, 7/8,
complying with AES-3id-1995
Timecode output
TIME CODE OUT
BNC type (1), SMPTE timecode,
1.0 Vp-p, 75 Ω, unbalanced
Remote control connectors
REMOTE (9P) D-sub 9-pin (2) female, complying with
RS-422A
VIDEO CONTROL
D-sub 9-pin (1) female, complying with
EIA RS-423
GPIO D-sub 15-pin (1), input: CMOS 5 V,
output: open-collector
(network) RJ-45 type (1)
1000BASE-T: complying with
IEEE802.3ab
100BASE-TX: complying with
IEEE802.3u
10BASE-T: complying with IEEE802.3
USB connector
USB 3.0 Super Speed USB (USB 3.0) Type-A (1)
Supported on the XDS-PD2000 only. An
optional XDBK-109 must be installed
to use this connector.
Other
MAINTENANCE connectors
High Speed USB (USB 2.0) Type-A (3)
(1 on front panel, 2 on rear panel)
Super Speed USB (USB 3.0) Type-A (1)
(rear panel)
PCIe expansion slot
× 8 slot (25 W) (2)
Media drives
Internal storage XDS-PD1000: Three units of 500 GB
HDD (Data: 2 HDDs; Fault tolerance:
1 HDD)
XDS-PD2000: Two units of 256 GB SSD
21
Specifications