Sennheiser SET 810 Quick Instructions

Quick instructions
Set 810

Connecting the system components

Plug in one end of the connecting cable
If necessary, use one of the adapters
ting cable to the socket
Connect the mains unit
Place the receiver into the transmitter's charging compartment
Before you use the rechargeable battery
Adjust the volume on your sound source(TV Set) to a sufficient, medium level.

Switching on and using the stethoset receiver

The receiver automatically switches on when you pull the earbows apart.
First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level .
If you cannot hear anything through the receiver, increase the volume on your sound
source.

Switching the stethoset receiver off

The receiver automatically switches off when you take it off.
Charging the stethoset reciever
Place the receiver into the transmitter's charging compartment
pressure. With a fully charged battery, the operating time is approx. 4 hours.
For details on the use of the Set 810, please refer to the enclosed operating instructions.
Sennheiser electronic GmbH & Co. KG
30900 Wedemark, Germany
A
B
C
to the socket on your sound source (e.g. television).
, (not included)or
LINE on the transmitter.
to the transmitter
for the first time, charge it until the LED lights up green.
Phone +49 (5130) 600 0
Fax +49 (5130) 600 300
www.sennheiser.com
. Plug in the other end of the connec-
and to the mains.
.
without exerting too much
Printed in Germany
Publ. 04/07
xxxxxx / A01