Steps
1. Using the alignment posts and rubber grommets, place the speakers in the slots on the palm-rest assembly.
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Adhere the tape to secure the speaker cables.
4. Connect the speaker cable to its connector on the system board.
5. Connect the USH board cable, LED cable, and touchpad cable to its connectors on the system board.
Next steps
1. Install the
3-cell battery
2. Install the
base
cover.
3. Follow the procedure in
Fan
Removing the fan
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
3-cell battery
4. Remove the
WLAN
card.
About this task
The following images indicate the location of the fan and provide a visual representation of the removal procedure.
44
Removing and installing components
or
4-cell
battery.
after working inside your
before working inside your
or
4-cell
battery.
computer.
computer.