Table of Contents
Advertisement
Installation
1
Leveling the Kegerator
□
It is important for the kegerator to be leveled for optimum ef ciency.
□
It can be raised or lowered by rotating the plastic sheaths around each of the feet on the bottom of the machine.
□
If you nd that the surface is not level, rotate the feet until the kegerator becomes level. You may need to make
several adjustments to level it.
□
If available, place a carpenter's level on top of the product to see if the kegerator is level from front to back and
side to side.
□
To adjust the height of the kegerator, simply turn the feet (right = lower / left = raise).
IMPORTANT:
installation.
2
Removing the Plug
□
Carefully remove the tower plug (Q) located on the
top of the unit by opening the cabinet (G), and with your hand.
□
Push the tower plug (Q) through the top of the cabinet (G) from
the inside.
□
Use a at head screwdriver as a prying tool if necessary.
3
Mounting the Tower
□
Place the black rubber tower gasket (4) at on the
top of the cabinet (G) and line up the pre-drilled holes.
□
Unbox the beer tower (O) and unravel the beer line hose (P)
from the bottom. Feed the clear beer line (P) through the
large opening at the top of the cabinet (G).
□
Place the beer tower (O) on top of the unit and align the screw
holes at the bottom of the beer tower (O) to the pre-drilled holes
located on the top of the cabinet (G). Secure the tower (O) by
attaching the four tower screws (3) with a phillips head
screwdriver to the top of the cabinet (G).
□
The faucet connection for the tower (O) should now face the front
of the cabinet (G).
□
If the faucet (2) is not facing the front of the cabinet (G), remove it and
reinstall it to the proper position.
□
Screw the black faucet handle (1) onto the faucet (2).
4
Installing the CO2 Regulator and Tank
□
Feed a hose clamp (10) over the end of the CO2 gas line (M).
□
Attach that end to the gas line connector (7) on the CO2 regulator (L).
□
Tighten the clamp to prevent leaks. Leave about ½ inch between
the top of the clamp and the end of the hose.
□
Attach the CO2 regulator (L) to the CO2 tank (9) by screwing the
regulator nut onto the CO2 tank (9) valve and tightening with an
adjustable wrench.
Kegerator should be level before
G
10
7
Please contact 1-855-847-7264 for further assistance.
Q
1
2
O
3
4
P
M
L
7
9
HOMEDEPOT.COM
5
G
Advertisement
Table of Contents
