Pre-Operation; Before You Begin; Setting Up The Appliance; Tools Required - Vissani VXK320BSSE Use And Care Manual

Pre-operation

BEFORE YOU BEGIN

IMPORTANT:
back or side for any length of time during this
process, it must be allowed to remain upright
for 24 hours before plugging it in to avoid
damage to the internal components.
Read instructions carefully before operating.

SETTING UP THE APPLIANCE

□
Before using your kegerator.
The kegerator should be installed in accordance with local
electrical code requirements. The kegerator should also
be placed in a location that is strong enough to support its
total weight, keeping in mind that it will weigh substantially
more when fully loaded than when empty. Before you plug
the kegerator into a power supply, be sure to let it stand
upright for at least 24 hours to allow the compressor's oils
to settle.
□
Finding a suitable location.
To ensure the kegerator will last, install it in a location where
there is proper air circulation and electrical connections.
Keep the refrigerator away from heat and direct sunlight.
This refrigerator is designed for indoor use only and should
not be used outdoors. It should not be placed in a built-in
or recessed area as it is designed to be a freestanding
kegerator.
□
The following dimensions are the recommended
clearances around the beer dispenser.
Sides: 2 to 3 in. (76 mm)
Back: 4 to 5 in. (127 mm)
□
Providing a proper power supply.
Before you move your kegerator into its nal location, it is
important to make sure you have the proper electrical
connection:
□
A standard electrical supply (115 V, 60Hz), properly
grounded in accordance with the National Electrical
Code and local codes and ordinances, is required.
□
It is recommended that a separate circuit, serving only
your kegerator, be provided. Use receptacles that
cannot be turned off by a switch or pull chain. The fuse
(or circuit breaker) size should be 15 Amps.

TOOLS REQUIRED

Flat head screwdriver
If the appliance is placed on its
WARNING:
and install the kegerator. Failure to do so
can result in back or other injury. Carefully
remove the packaging materials. Remove
any shipping tape and glue from your
kegerator before using. Do not use sharp
instruments, rubbing alcohol, ammable
or glue. These products can damage the
surface of your kegerator.
Phillips head screwdriver
5
Please contact 1-855-847-7264 for further assistance.
Use two more people to move
uids, or abrasive cleaners to remove tape
WARNING:
□
Plug into a grounded 3-prong outlet.
□
Never remove the grounding prong from
the plug.
□
Never use an adapter to bypass the
grounding prong.
□
DO NOT use an extension cord.
□
Failure to follow these instructions can
result in re, electrical shock, or death.
Do not remove any safety,
IMPORTANT:
warning, or product information
labels from your kegerator.
Wrench
HOMEDEPOT.COM