Advertisement
Figure 3-2: Installing Housing
Large dome with lining
4.
Connect the network access port and power
supply of the multihead cable (if not using
PoE).
5.
Adjust the lens focal length and video angle
range. This should be done while viewing the
camera's video feed.
a. Remove the lining by pressing the arrows
marked on it, as shown in figure 3-3.
Figure 3-3: Removing Lining
Large dome with lining
b. Slightly loosen the slotted screw as shown
in figure 3-4 to make triaxial adjustments
to the camera.
Figure 3-4: Three-Axis Adjustment
Large dome
Mini dome
Mini dome
Mini dome
c. Loosen the focus lever and gently move
the zoom lever to adjust the focal length
to the desired position (large dome only).
d. Once properly adjusted, tighten all screws.
Note
● These steps may not apply to all models; please refer
to the actual product.
● The image might appear blurry while the focus lever
is in use; move the zoom lever to fine-tune the image
and lock the lever when the image is clear.
● If the camera lens has auto-focus, set the focus value
in the camera's web interface under Settings > Lens
Control.
6.
If applicable, insert SD card as shown in
figure 3-5.
Figure 3-5: Inserting SD Card
Large dome
7.
Re-attach the lining to the main body. Align
the dome cover with the main body and
attach as shown in figure 3-6.
Figure 3-6: Assembling Lining & Cover
Large dome
4. Device Ports
Note:
Different devices may have different ports and
multi-head cables; please refer to the actual product.
Note:
Lens adjustment is only applied for large domes.
Mini dome
Mini dome
Advertisement
