Advertisement
Advertisement
Table of Contents
Related Manuals for Motorola solutions RMN5052
Summary of Contents for Motorola solutions RMN5052
- Page 1 COMPACT AND HEAVY DUTY MICROPHONES RMN5052 RMN5053 USER GUIDE...
- Page 3 FOREWORD Product Safety and RF Exposure Compliance Before using this product, read the operating instructions for safety usage contained in the Product Safety and RF Exposure booklet enclosed with your radio. ATTENTION! These microphones, when attached to the mobile radio, are restricted to occupational use only to satisfy FCC RF energy exposure requirements.
-
Page 4: Installation
INTRODUCTION The RMN5052 and RMN5053 Compact and Heavy Duty Microphones provide a convenient means of communicating by having a microphone and a push-to-talk (PTT) button in a single, hand held accessory. Both microphones include a coiled cord with strain relief, a hang-up... -
Page 5: Vehicles Equipped With Airbags
VEHICLES EQUIPPED WITH AIRBAGS An airbag inflates with great force. W A R N I N G DO NOT place objects, including communication equipment, in the area over the airbag or in the airbag deployment area. If the communication equipment is improperly placed and the airbag inflates, this could cause serious injury. - Page 6 Mounting the Hang-Up Clip Once an installation location has been decided, perform the following steps: 1. Verify that the selected mounting surface is strong enough to support the mounting hardware and the microphone. 2. Use the base of the hang-up clip as a template to center punch and drill two 3mm (1/8”) diameter holes.
-
Page 7: Microphone Operation
MICROPHONE OPERATION Transmitting To transmit using your microphone: 1. Hold the microphone approximately five centimeters (two inches) from your mouth. 2. Press the PTT button. 3. Speak directly into the grill openings located in the upper center of the microphone face. 4. -
Page 8: Coiled Cord Replacement
Disconnecting the Microphone from Radio 1. Turn the locking collar on the radio end of the microphone 1/4 turn counterclockwise. 2. Pull cable from accessory interface connector to release. COILED CORD REPLACEMENT To remove the RMN5053 coiled cord: 1. Rotate the locking collar at the base of the microphone in a counterclockwise direction until it stops. - Page 9 SERVICE Other than the replaceable cords, the RMN5052 and RMN5053 Compact and Heavy Duty Microphones are not repairable. Order replacement microphones as required. The following replacement parts are available through your Motorola Solutions service representative. Part Number Part Description Replacement Cord, Compact 3075336B07...
- Page 10 *6881098C80* 6881098C80-AC...
Need help?
Do you have a question about the RMN5052 and is the answer not in the manual?
Questions and answers