Table of Contents
Advertisement
Third rack
14 Basic Operation
Ba s i c Ope r a t i o n
Ba s i c Ope r a t i o n
14.1 Protection against unintentional
operation
Your dishwasher has a built in feature to help prevent
unintentional operation, e.g. by children. After starting the
appliance, the door has to be closed within 4 seconds,
otherwise the operation will be paused. If this occurs,
follow the steps below to restart your dishwasher.
For top button controls: Press
1.
For front button controls: Close the door and press
2.
The wash cycle will resume.
a
Notes
Unintentional operation is activated when:
¡
– Pressing Start to begin a wash cycle
– Setting Delay time and pressing Start
– Opening the door while Delay time is active
– Opening the door during a wash cycle.
This feature cannot be deactivated.
¡
14.2 Opening the appliance door
If the electric childproof lock is not activated, press on
1.
the upper middle section of the appliance door.
If the electric childproof lock is activated, press on the
2.
upper middle section of the appliance door twice with a
short interval in between.
The appliance door will open automatically.
a
14.3 Switching on the appliance
Touch
with a short 1 second touch.
▶
The standard cycle is set by default.
The buttons on the appliance are touch sensitive and
only require a quick, gentle touch.
If you do not perform any actions on the appliance for
10 minutes, it will automatically switch off.
a
a
and close the door.
.
a
14.4 Setting a cycle
To adjust the wash cycle to the soiling level of the
dishware, select a suitable program.
Press the right cycle button.
▶
The cycle is set and the cycle button flashes.
14.5 Setting options
You can set options to complete the chosen wash
program.
Note: The available options depend on which program is
selected.
Press the button for the relevant option.
▶
The option is set and the option button flashes.
14.6 Setting the electronic delay time
You can delay the start of the wash cycle by up to
24 hours.
Press
.
1.
Press
or
repeatedly until the display shows the
2.
right time.
Depending on the setting of the time display, the end of
the program is shown on the display by "Finish in" (e.g.
3h 25min) or "Finish at" (e.g. 3:20pm). You can change
this setting in the Basic settings → Page 31 .
To activate the electronic delay time, press
3.
Note: To deactivate the electronic delay time, press
for approx. 4 seconds.
14.7 Starting the wash cycle
Press
.
▶
The wash cycle has ended when the display shows
"Finished!".
Notes
If you want to add more dishware while the appliance is
¡
running, do not use the collecting tray as a handle for
the upper rack. You might touch the partially dissolved
tablet.
You can only change a cycle in progress if you can
¡
cancel it first.
→ "Terminating the wash cycle", Page 30
To save energy, the appliance switches off
¡
automatically 10 minutes after the end of the wash
cycle. If you open the appliance door immediately after
the wash cycle has ended, the appliance will switch off
after 4 seconds.
14.8 Interrupting the wash cycle
Press On/Off.
1.
The program is saved and the appliance switches off.
Press On/Off.
2.
Press
to resume the wash cycle.
3.
Basic Operation en-us
.
29
Advertisement
Table of Contents
