Remove The Camera Module - Lenovo Slim 7 Carbon Hardware Maintenance Manual

Figure 29. Peel off the LCD connector fabric
Step 2. Disconnect the EDP cable from the LCD panel and then peel off the panel cable fabric. Remove the
EDP cable.
Note: The panel cable fabric is not reusable. Replace it when replacing related FRU.
Figure 30. Remove the EDP cable
Go to https://support.lenovo.com/partslookup
replacement parts:
LCD connector fabric
Panel cable fabric
EDP cable
Removable tape

Remove the camera module

Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD unit" on page 40
"Remove the hinge cover" on page 43
"Remove the bezel cover" on page 43
"Remove the LCD panel" on page 44
Step 1. Remove the camera board with camera cable from LCD panel.
to look up the Lenovo part numbers of the following
.
Chapter 4 Removing a FRU or CRU
47