1. Remove the computer cover. See "Computer cover" on page 55.
2. Remove the front bezel. See "Front bezel" on page 56.
3. Disconnect the signal cable and the power cable from the storage drive.
Removal steps
Optical drive bracket
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
For access, do the following:
1. Remove the computer cover. See "Computer cover" on page 55.
2. Remove the front bezel. See "Front bezel" on page 56.
3. Remove the optical drive. See "Optical drive" on page 58.
.
Chapter 6
Hardware removal and installation
59