Initial Use - Sanitas SBC 22 Instructions For Use Manual

Information on the display:
The corresponding drawings are shown on page 3.
Systolic pressure
1
Diastolic pressure
2
Calculated pulse rate
3
Cardiac arrhythmia
4
symbol
5 Pulse symbol
Release air
6
User memory /
7

6. INITIAL USE

Inserting the batteries
• Remove the battery compartment lid on the left side of
the device .
A
• Insert two 1.5 V AAA micro (alkaline type LR03) batteries.
Make sure that the batteries are inserted the correct way
round in accordance with the markings
rechargeable batteries.
Risk indicator
8
Memory space number/
9
memory display for
average value ( A A ),
morning ( AM AM ),
evening ( PM PM )
Battery replacement
10
symbol
Time and date
11
. Do not use
A
• Close the battery compartment lid again carefully.
If the battery replacement symbol
no longer perform any measurements and must replace all
batteries.
Adjusting the settings
You must make sure that the device has the correct settings
before use in order to be able to make full use of all functions.
Only by doing so can your measurements with associated
date and time be saved and accessed later by you.
There are two different ways to access the menu from
which you can adjust the settings:
• Before initial use and after each time you replace the
battery:
When inserting batteries into the device, you will be taken
to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off press and hold the START/
STOP button for approx. 5 seconds.
In this menu you can adjust the following settings in succes-
sion:
Hour format
28
is displayed, you can
Date Time