Power Supply; Water Supply; Minimum Installation Distance - Grohe Sensia IGINA 39378SH0 Installation Manual

Do not place fire source such as
cigarettes near this product.
Failure to do so may cause fire.
CAUTION
The toilet bowl is made of ceramics,
and ceramics are fragile. Note the
following when handling the toilet
bowl:
– Prior to installation, make sure
that the toilet bowl is in a good
condition and not damaged.
– After installation, check the toilet
bowl for any damages.
Failure to do so may cause injury,
water leakage and/or flooding.
Wash out foreign materials or rust
inside the pipes before connecting
the product.
Failure to do so could damage the
internal parts of the product, which
may cause water leakage and/or
flooding.
Note the following when using the
strainer:
– Close the water shutoff valve
when removing the strainer.
– When installing the strainer,
tighten it fully so there is no gap.
– Check that the O-ring is free from
foreign materials when attaching it.
If foreign materials are attached
to the O-ring, it may cause
flooding due to water leakage.
Adjust the water shutoff valve and
check for water leakage after the
installation.
It may cause water leakage and/or
flooding.
If the water is expected to be frozen,
drain the water out from the product
until rendering it to the client.
Failure to do so may cause fire,
water leakage, and/or flooding due to
damage from freezing.
Drain the air from the pipes after any
building construction or renovation,
or when water supply is restored
after an interruption.
If the water supply contains air, it
may cause damage or malfunction to
the product or pipes. There is a
danger of injury or damage to the
building or furniture due to flooding.

Power Supply

Install the cord and outlet according to the specifications
below.
The power distribution work should be done by an
electrical contractor.
• Use an AC 220V power supply with a consumption
rating.
If the product is used with other electric appliances, set
the corresponding number of outlets.
• The wiring should be appropriate for the rated power
consumption.
• Set the outlet within the reach of the cord and high
enough from the floor so that water does not reach it.
The length of the power cord is 1000 mm.
Do not insert the power plug into the outlet until the
installment is complete. There is danger of malfunction.

Water Supply

• Only use potable water as the water supply.
Using a different water supply (industrial water, well
water, etc.) may cause the durability of the electrical and
mechanical components to deteriorate, resulting in an
accident or malfunction.
• The water pressure must be more than 0.1MPa
(when flows) or less than 0.75MPa (hydrostatic
pressure).
If the water pressure is lower than the above, please
consult your dealer.
• If the water pressure is higher than 0.75MPa,
decompress the pressure by using a decompression
valve.

Minimum Installation Distance

For the required minimum installation clearance, refer
to the figure below.
*1 A space of 70 mm or more on each side of the product
is recommended.
If it is less than 70 mm, it may hinder the operation.
(25)
1050 (min.)
Firmly fix the water supply pipe
An impact applied to the hose due to high water pressure
may cause vibrations.
Fix the water supply pipe firmly so that it does not loosen.
There is a danger vibration or flooding.
70 (min.)*1
384
800 (min.)
70 (min.)*1
Unit: mm
7
GB