Installing Loose Shipped Parts - Scotsman IS160 Service Manual

FOR THE INSTALLER: Installation of Loose Shipped Parts
Sink:
1. Remove splash panel from unit.
2. Slip a worm drive clamp over the drain tube as
shown.
3. Hold the drip tray up at an angle of about 30
Slide the drain fitting into the drain tube.
DRAIN
TUBE
MOUNTING
TABS
4. Tighten the worm-drive clamp.
5. Hang the drip tray onto the mounting tabs at the
base of the unit. Replace the splash panel.
o
.
SINK
DRAIN
FITTING
SPLASH
PANEL
ICE CHUTE
August 1995
Page 3
Ice Lever*, Ice chute, and Fluorescent Tube
1. Slide out the ice chute mounting panel.
2. Insert the ice lever into the slot as shown.
3. Swing the lever through the slot from right to
left and let it hang freely.
4. Twist the fluorescent tube into the sockets.
5. Replace the ice chute mounting panel.
6. Insert the ice chute into the panel and twist
clockwise 1/3 turn.
7. Attach the upper front cover by pushing the
strikes on the cover into the catches on the unit.
* Optional depending upon unit configuration.
ICE CHUTE
MOUNTING
PANEL
IS160 and IS220
LEVER
SLOT