Gear Motor - Scotsman FME2400 Service Manual

REMOVAL AND REPLACEMENT: Gearmotor
SEAL
COVER &
OUTPUT GEAR
ASSEMBLY
Note: There are two gear motors in each
unit.
Disconnect electrical
power before beginning.
WATER SHED
January 1994
NME1850 & FME2400
CENTRIFUGAL
AUGER DRIVE MOTOR
ROTOR BEARING
SEAL
To Remove and Repair the Gearmotor Assembly:
(Assuming that the procedures through removal of the
water seal have been performed.)
1. Remove the electrical wires from the gear drive motor.
2. Unscrew the 4 cap screws holding the gear motor to
the base of the machine.
3. Remove the gear motor from the ice maker.
Bench test the gear motor, check for oil leaks, noise, and
amp draw.
To Inspect the gear motor.
A) Remove the cap screws holding the gear motor case
halves together and pry the two cases apart.
B) To lift off the cover, lift up until you can feel internal
contact, then pull the cover towards the output gear end,
and then lift the cover (with drive motor attached) up and
away from the gear motor case.
Note: The gearcase cover, output gear, bearings and
output shaft are a pressed together assembly.
Page 29
SWITCH