Scotsman FME2400 Service Manual page 17

MAINTENANCE AND CLEANING
These steps must be followed for both systems.
1. The bin control uses devices that sense light,
therefore they must be kept clean enough so that
they can ''see''. At least twice a year, remove the
bin control sensors from the base of the ice chute,
and wipe the inside clean, as illustrated.
2. The ice machine senses water level by a probe
located in the water reservoir. At least twice a
year, the probe should be removed from the
reservoir, and the tip wiped clean of mineral
build-up.
PULL UP TO
REMOVE PROBE
RESERVOIR
CLEAN THE
WATER LEVEL
PROBE
///////////////////////////////////////////
CAUTION: THE TIP IS
MADE OF GLASS
//////////////////////////////////////////
3. The bearing in the breaker should also be
checked at least two times per year .
A. Check the bearing by:
removing the ice chute cover
unscrewing the ice sweep
removing the water shed
unscrewing the breaker cover.
unscrewing the auger stud
Disconnect electrical
power before beginning.
January 1994
NME1850 & FME2400
ICE LEVEL SENSORS:
SLIDE TO REMOVE
CLEAN THE
LIGHT SENSORS
Inspect the assembly, looking for wear.
See Removal and Replacement to replace
bearing or seals. Reverse to reassemble.
4. Check and tighten all bolts and screws.
Page 17
ICE SWEEP
BREAKER
COVER