Advertisement
Getting started
Battery installation & charging
Install the battery as shown below. After installing the battery, you might be
able to make and receive short calls. For best performance, charge the
handset for at least 16 hours before use. When not in use, place the handset in
the telephone base or charger. See the table on page 63 for battery
opearating times.
If the battery is depleted, it may take approximately four minutes to charge the
handset before it can resume screen display. The screen will continue to
display LOW BATTERY until the battery has charged for approximately one
hour.; the backlight on the handset disables when in LOW BATTERY mode.
Battery indicators
The screen is blank.
The screen shows
PLACE IN CHARGER
and the battery icon
flashes
The screen shows LOW
BATTERY, the battery
icon flashes, and the
handset beeps once
every minute.
The screen shows
HANDSET X.
Battery status
Battery has no charge
and the handset
cannot be used.
Battery has very little
charge the handset
cannot be used.
Battery has enough
charge to be used for a
short time. There is not
yet enough charge to
use the speakerphone.
Battery is charged.
5
Action
Charge until the screen
shows LOW BATTERY
(at least 10 minutes).
Charge until the screen
shows LOW BATTERY
(about four minutes).
Charge until the screen
shows HANDSET X
(about one hour).
To keep the battery
charged, place it in the
base or charger when
not in use.
Advertisement
