Led Indicators - Tenda RX27 Pro Quick Installation Manual

LED indicators

After the router is powered on for about 40 seconds, the system completes startup. The
status of the LED indicator is shown in the following table.
LED indicator
Node Type
Status
Solid green
Blinking green
slowly
Primary node
Blinking green
fast for 2
minutes
Blinking red
slowly
Solid green
Solid yellow
Solid red
Secondary
node
Blinking green
fast
Blinking red
slowly
07
LED
indicator
Description
The system is starting up, or the router is already
connected to the internet.
The router is not connected to the internet.
The router is pending for or performing WPS
negotiation or Mesh networking.
The router failed to connect to the internet.
Networking succeeds. Good connection quality.
Networking succeeds. Fair connection quality.
Networking succeeds. Poor connection quality.
The router is networking with another node.
The router failed to connect the internet or network
with another node.
Jack, ports and buttons
POWER WPS Reset WAN
Jack/Port/
Description
Button
Power jack.
POWER
Please use the included power adapter to connect this jack to a
power source for power supply.
WPS/Mesh button.
• WPS: When it is used as a WPS negotiation button, you can
connect to the WiFi network of the router without entering the
WiFi password.
Method : Short press the button (for about 1 second), and the
LED indicator blinks fast. Within 2 minutes, enable the WPS
function of the other WPS-supported device to establish a
WPS connection.
WPS
• Mesh: When it is used as a Mesh networking button, you can
extend your network with another device that supports the
Mesh function.
Method : Press this button for about 3 seconds. The LED
indicator blinks green fast, which indicates the device is
searching for another device to form a network. Within 2
minutes, press the MESH/WPS button of another device for 1 to
3 seconds to negotiate with this device.
Reset button.
When the router is working normally, hold the button down using a
Reset
needle-like item (such as a pin) for about 8 seconds, and then release
it when the LED indicator blinks red fast. The router is reset.
10/100/1000 Mbps auto-negotiation WAN port.
WAN Used to connect to a modem or the Ethernet jack using an Ethernet
cable for internet access.
10/100/1000 Mbps auto-negotiation LAN port.
1, 2
Used to connect to computers, switches or game machines, etc.
10/100/1000 Mbps auto-negotiation LAN/IPTV port.
IPTV/3 It is a LAN port by default. When the IPTV function is enabled, it can
only serve as an IPTV port to connect to a set-top box.
1 2 IPTV/3