Location & Assembly - Scotsman CME256 Product Manual

CME256, 506, 656, 806: AutoIQ™ Cubers
Location & Assembly:
Air cooled models take room temperature air in
from the left and right sides, and discharge warm
air out the back. If installed in a corner or with
another cabinet next to the right side, an air baffle
could be installed on the back of the cabinet to
minimize air re-circulation.
A 6 inch minimum clearance on the back, left and
right sides is required for operation and service of
this machine.
Note: Although the machine will function, ice
capacity of air cooled machines will be
significantly reduced with only 6 inches of
clearance at the sides, back and top.
Unpacking and Assembly:
Begin with unpacking the ice storage bin. Remove
the carton, and using part of the carton as a
cushion, tip the bin on its back to remove the skid
and attach the legs or casters. Note: Stacked
applications may not use casters.
Return the bin to an upright position. Check the bin
top gasket for gaps and tears, fill any in with food
grade sealant prior to placing the ice machine on
the bin.
If the ice machine has not been unpacked, do so
now. Remove the carton from the skid. Lift the ice
machine off the skid directly onto the bin.
Note: The machine is heavy! Use a mechanical
hoist if necessary.
Secure the ice machine to the bin with the
hardware provided (two metal straps and 4 bolts).
Air Flows in the Sides
and Out the Back
July 2004
Page 4
Cabinet Panel Removal:
Note: The top panel holds the upper edges of the
side panels in place.
1. Front Panel, "A" series: Remove the front
panel by removing the four screws connecting the
front panel to the left and right sides.
Front Panel "C thru F" Series: Remove top two
screws, and pull the bottom of the panel away
from the machine to unsnap it from the machine.
2. Remove 2 screws at the front edge of the top
panel, and pull the top panel forward until it
releases from the tabs connecting it to the back
panel.
3. Remove the screws at the front edge of each
side panel, and pull them forward until they
release from the tabs connecting them to the back
panel.
Remove
Second
Remove
First
Removal of Panels