Assembly Procedures - Hitachi CG 27EASP Safety Instructions And Instruction Manual

English

ASSEMBLY PROCEDURES

Drive shaft to engine (Fig. 1)
Loosen tube locking bolt (1) about ten turns so that
the bolt point will not obstruct drive shaft tube to be
inserted. When inserting drive shaft tube, hold the
tube locking bolt outward preventing inside fi tting
from obstructing as well.
Insert the drive shaft into the clutch case of the
engine properly until the marked position (2) on the
drive shaft tube meets the clutch case.
Some models may come with the drive shaft already
installed.
1
2
NOTE
When it is hard to insert drive shaft up to the
marked position on the drive shaft tube, turn
drive shaft by the cutter mounting end clockwise
or counter-clockwise. Tighten tube locking bolt
lining up the hole in the shaft tube. Then tighten
clamp bolt securely.
Installation of attachment
1. Join the attachment in place of it.
2. Make sure the lock pin (3) fi ts in the location hole
(4) of tube and that the tube will not come off .
(Fig. 2)
3. Tighten the knob nut (5) securely. (Fig. 2)
5
4
8
1
2
Fig. 1
3
Fig. 2
Installation of handle
WARNING
When you use steel/rigid blades on straight
shaft trimmers or brush cutters, always use
a barrier bar (6) and shoulder harness with
the loop handle. (Fig. 3)
Attach the handle to the drive shaft tube with the
angle towards the engine.
Adjust the location to the most comfortable position
before operation.
NOTE
If your unit has handle location label on drive
shaft tube, follow the illustration.
Remove the handle bracket (7) from the assembly.
(Fig. 4)
Place the handles and attach the handle bracket with
four bolts lightly. Adjust to appropriate position. Then
attach it fi rmly with the bolts.
6
Fig. 3
7
Fig. 4