Assembly Procedures - Hitachi CG 23ECP(SL) Safety Instructions And Instruction Manual

English

ASSEMBLY PROCEDURES

Installation of handle (Fig. 1)
Attach the handle to the drive shaft tube.
Adjust the location to the most comfortable position
before operation.
Make sure to securely attach the handle with the 4
bolts.
NOTE
If your unit has handle location label (1) on drive
shaft tube, follow the illustration.
WARNING
Do not use metal or plastic blade cutting
attachments.
Installation of cuttingt attachment guard
WARNING
● Do not start or operate unit unless each
guard is properly assembled to unit.
● If an incorrect or faulty guard is fi tted, this
may cause serious personal injury.
CAUTION
Some cutting
equipped with sharp line limiters. Be careful
with handling it.
(CG23ECP (SL))
Aligning to the position indicated by the guard
location label (2), fi rmly secure the cutting
attachment guard to the drive shaft tube with the bolt
(3) and guard bracket (4). (Fig. 2)
2
8
1
Fig. 1
attachment guards
3
4
Fig. 2
(CG23ECP (SLB))
Insert the cutter case between the guard bracket
and cutting attachment guard, and secure it with the
bolt. (Fig. 3)
WARNING
● lf unit is operated without a sharp line
limiters, the line will become too long, the
engine will overheat, and engine damage
may occur.
● Check sharp line limiters surely cut nylon
line when operating.
Installation of cutting attachment
WARNING
● Install the
and securely as instructed in the handling
instructions.
If not attached properly or securely, it may
come off and cause serious and/or fatal
injury.
● Do not install or remove cutting attachments
while the engine is running.
are
● Always use
attachments and metal fi ttings.
Installation of semi-auto cutting head
1. Function
Automatically feeds more nylon cutting line
when it is tapped at low rpm (not greater than
6,000 min ).
–1
Specifi cations
Type of
Code No. attaching
screw
Female
6600570
screw
Female
6601376
screw
Applicable nylon cord
Cord diameter: 3/22˝ (Φ2.4 mm) Length: 16.3 ft (5 m)
Fig. 3
cutting attachment
genuine Hitachi
Size of
Direction of
attaching
rotation
screw
M10×P1.25-
Counterclockwise
LH
M8xP1.25-
Clockwise
RH
properly
cutting