Additional Maintenance - Scotsman CME2006R User Manual

Additional Maintenance

To Properly Place the Evaporator Covers
Removal:
1. Remove right front panel.
2. Push up on evaporator cover and swing out the
base.
3. Use the finger holes to pull the lower inside
cover down and swing it out from the machine.
4. Pull upper inside cover out from behind the
pump hose.
Note: ALL COVERS MUST BE PROPERLY IN
PLACE or the MACHINE WILL MALFUNCTION.
Insert Bottom Tabs in 5th
Slot of Cube Deflectors
Replacement:
1. Return upper inside cover to its original position.
2. Using finger holes to control the part, insert the
two tabs on the bottom of the lower inside cover
into the 5th slot of each cube deflector.
3. Push down and insert upper edge of the lower
inside cover into the slot on the bottom of the
evaporator bracket.
4. Insert evaporator cover into plastic slot at the
top of the compartment and then place the lower
end onto the reservoir wall.
To drain reservoir (if desired):
1. Remove left front panel.
2. Push and hold the Off button.
3. Remove screw holding reservoir cover, pull inlet
tube out of reservoir cover, lift cover out of machine.
4. Locate drain plug (at the back of the reservoir).
Note: Top unit of a stack will drain thru the bottom
machine.
5. Pull the drain plug to release the water. On units
over an ice storage bin the water will drain into the
bin.
6. Reverse steps 2-5 to reassemble.
7. Push and release Freeze button.
8. Return the left front panel to its original position.
Or: Push and
Hold the Clean
Button for 3
Seconds to
Activate Purge
Valve
Or: Drain the Reservoir by Holding Purge
Valve Open While in a Clean Cycle
To Sanitize the Ice Storage Bin
1. Remove all ice.
2. Remove baffle.
3. Switch ice machine OFF or wait for it to be in a
cleaning cycle.
4. Mix a 1 gallon solution of warm (95-115
and sanitizer. Follow local codes for sanitizer.
5. Wash or spray the entire interior of the ice
storage bin with the sanitizer solution. This includes
the bottom of the ice machine and the inside of the
door, the door gaskets (if any) and door frame.
6. Pour excess sanitizer into the bin to flush the
drain system.
7. If the approved sanitizer requires a rinse, rinse
all interior surfaces with potable water.
July 1998
Page 27
CME2006R
o
F.) water