Cub Cadet 769-11758A Manual page 19

Operation
Starting the engine
Note
The choke is used for starting the device
with a cold engine. Some models have no
choke. The engine is automatically set to
separate instructions in the engine operating
manual.
Open the fuel tap (for the left or right fuel tank).
Sit down on the driver's seat.
Switch the parking brake on.
Set the throttle to .
If the engine is cold, pull the choke or set the
throttle to .
Press the ignition key
Insert the ignition key into the ignition lock.
Turn the ignition keyto
up.
Release the ignition key.
Set the ignition key to
Note
A start attempt should take a maximum of
5 seconds. Wait 30 seconds before trying
again.
Reset the choke / throttle slowly until the engine is
running smoothly.
Stopping the engine
Set the throttle to the middle position.
Let the engine run for approx. 20 seconds.
Set the ignition key to
Remove the ignition key.
Switch the parking brake on.
769-11758A
:
until the engine starts
.
.
Driving
WARNING !
Risk posed by abrupt starting, sudden
stopping and driving at an excessively high
speed.
Risk of accidents
Drive slowly and brake slowly.
Do not drive at excessive speed.
Be particularly careful when reversing.
Never change the direction of travel with-
When entering corners, always reduce
your speed and adjust the speed to the
turning radius (the tighter the corner, the
lower the speed).
Never adjust the steering column or the
driver's seat when in motion.
Never operate the device without the
rollbar or cutter deck.
Do not operate the device with the rollbar
folded down.
Always wear a seat belt when the rollbar
is folded up.
Do not fasten the seat belt when the
rollbar is folded down.
If the device is moving gently (crawling),
even though you are not pressing the drive
pedals (= neutral position), switch the device
service centre.
Note
parking brake is engaged. In such cases,
through the safety locking system.
Forward pedal
A
Reverse pedal
B
Sit down on the driver's seat.
Put on the seat belt.
Start the engine.
Release the parking brake.
To drive away, step on the accelerator
pedal [A] / [B].
Note
The further you step on the accelerator
pedal, the quicker the machine will go.
EN
19