Defrosting The Refrigerator; Defrosting The Freezer Compartment; Troubleshooting - Linea DOMO DO91702R Instruction Booklet

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 39

DEFROSTING THE REFRIGERATOR

The refrigerator defrosts fully automatically.
While the cooling is running, beads of condensation or
hoarfrost form at the back of the refrigerator. This is normal. It
is not necessary to wipe off the condensation or frost. The rear
panel defrosts automatically. The condensation runs into the
condensation channel and is conveyed to the compressor from
where it evaporates.
Note: Keep the condensation channel and drainage hole clean, so
that the condensation can run out.

DEFROSTING THE FREEZER COMPARTMENT

A layer of frost in the freezer will impair refrigeration of the frozen food and increases power
consumption. Remove the layer of frost regularly. Do not scrape off frost or ice with a knife or pointed
object. Doing this may damage the refrigerant tubes.
1.
Remove the frozen food and place temporarily in a cool location.
2.
Disconnect the appliance from the mains socket.
3.
To accelerate the defrosting process, place a pan of hot water on a stand in the freezer.
4.
Wipe up condensation with a cloth or sponge.
5.
Wipe dry the freezer compartment.
6.
Plug in the appliance and adjust the temperature control knob as desired.
7.
Put the frozen food back in the freezer.
TROUBLE SHOOTING
Frequently, a problem is minor and a service call may not be necessary, use this trouble shooting guide for
a possible solution.
Does not work
·
Check connection of power cord to power source.
·
Check that the temperature controller is not in the 0 position.
·
Plug in unit.
·
Use proper voltage.
Cools too frequently
·
The temperature setting is too cool.
·
Close door securely.
·
Be sure that food is cool before inserting.
·
Do not keep door open for too long and minimize door openings.
·
Use proper voltage.
·
Do not place unit close to heat sources or direct sunlight.
Internal temperature not cold enough
·
Check connection of power cord to power source.
·
Plug in unit.
·
Check setting and adjust as needed.
·
Close door securely.
48
DO91702R

Advertisement

Table of Contents
loading

Table of Contents