Smart Card Reader; Removing The Smart Card Reader - Dell P174G Service Manual

Steps
1. Using the alignment posts and rubber grommets, place the speakers into the slots on the palm-rest and keyboard assembly.
2. Route the speaker cable along the bottom side of the palm-rest and keyboard assembly. Then secure the speaker cable into
the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the connector on the I/O daughter-board.
Next steps
1. Install the base cover.
2. Follow the procedure in

Smart card reader

Removing the smart card reader

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the speakers.
4. Remove the 2-cell battery
About this task
NOTE: This procedure applies only to computers shipped with a smart card reader installed.
The following images indicate the location of the smart card reader and provide a visual representation of the removal
procedure.
44 Removing and installing components
Before working inside your
Before working inside your
or the3-cell battery, whichever is applicable.
computer.
computer.