Table of Contents
Advertisement
SU4/U3 (VHR-M439 GB) Tue. Feb. 02/1999
ALTERNATIVE CABLE TV CONNECTIONS
Your VCR can receive all unscrambled cable channels
without the use of an external converter. If you wish to
view and record scrambled cable channels, you must
connect a converter/decoder as described below.
When the TV does not have a built-in cable converter
Connect the cable TV converter between the VCR and
the TV so that you can watch a cable TV program while
recording another program.
VCR
CATV
(Back panel)
75 ohm
coaxial
cable
CHANNEL
3
AC IN
When you have both cable and pay TV (scrambled channels)
NOTES:
œ With this method the TV and VCR receive the same
channel. Recording one program while watching
another is not possible.
Cable
converter/
Decoder
CATV
75 ohm
coaxial cable
NOTE TO CATV SYSTEM INSTALLER (USA only): This
reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular,
VHF/UHF
FROM ANT.
IN
RF
TO TV
4
OUT
(supplied)
VCR
(Back panel)
RF
CHANNEL
3
4
AC IN
12
Your local cable TV company will advise you of the
channels available in your area.
We recommend that you consult your cable TV company
to make sure that the cable is properly connected.
NOTE:
Set the TV channel to the cable converter output
channel (CH02 ~ 07).
Cable
converter
IN
OUT
(not supplied)
œ With this connection, the VCR must be set to the cable
converter/decoder output channel. (See next page.)
TV
(Back panel)
VHF/UHF
FROM ANT.
IN
TO TV
OUT
(supplied)
specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of
cable entry as practicable.
TV
(Back panel)
VHF/UHF
ANTENNA
IN
VHF/UHF
ANTENNA
IN
Advertisement
Table of Contents
