Warning Out Terminal - Sanyo SRC-850A Instruction Manual

OUTPUT TERMINALS

WARNING OUT Terminal

œ The WARNING OUT terminal output becomes 0 V
(Low) in accordance with the (WARNING OUT/EJECT
SET) menu.
WARNING OUT Terminal Output Setting
1
Press the MENU button to display the MAIN MENU.
2
Press the l (or j) button to select the "5.WARNING
OUT/EJECT SET" line, then press the ENTER
button.
ø The (WARNING OUT/EJECT SET) menu
appears.
<WARNING@OUT@SET>SET@UP
ALARM@@@@@@@@@@@@Y
NON@REC@@@@@@@@@@N
MECHA.PROBLEM@@@@Y
VIDEO@LOSS@@@@@@@Y
<EJECT@SET>
EJECT@MODE@@@@@@@EJECT1
OPERATION@@@@@@@@SLAVE
3
Press the ENTER button.
4
Press the l (or j) button to select the desired
mode, then press the ENTER button.
SET UP . . . . Set each item
ALL Y . . . . . . To set all items to "Y"
ALL N . . . . . . To set all items to "N"
œ If using the "SET UP" setting, continue with steps
5 to 7.
5
Press the l (or j) button until the item for warning
output is highlighted, then press the ENTER button.
6
Press the l (or j) button to set "Y" (warning is
given) or "N" (warning is not given), then press the
ENTER button.
ALARM. . . . . . . . . . . The output becomes 0 V
NON REC . . . . . . . . The output becomes 0 V
MECHA. PROBLEM . . . The output becomes 0 V
and "A" appears on the
digital display during alarm
recording
and "N" appears on the
digital display if the VCR
enters a mode other than
recording (i.e. recording
pause, stop mode, etc.)
during recording
and "M" appears on the
digital display when the
tape stops or other problem
with the internal mechanism
VIDEO LOSS . . . . . The output becomes 0 V
7
Repeat steps 5 and 6 when setting other items.
8
When finished, press the MENU EXIT button.
NOTES:
œ The "VIDEO LOSS" line does not appear if "VIDEO
LOSS" is set to "N" in the (GENERAL SET) menu.
œ Displays on the digital display take precedence over
other displays.
œ Canceling warning displays and output.
Press the STOP button once.
The warning display disappears from the digital
display.
Press the STOP button once more.
œ The buzzer will stop when a "VIDEO LOSS" or
"NON REC" warning is output. The buzzer and
these warning outputs will both stop when a
"MECHA. PROBLEM" warning is output.
œ The "ALARM" warning buzzer and output cannot
be cancelled.
œ The "VIDEO LOSS" and "NON REC" warning
output cannot be cancelled. Output will stop when
the status returns to the condition before the output
started.
œ If the system has shut down because of a
"MECHA. PROBLEM" warning, the output is
canceled when the ALL RESET button is pressed.
36
and "V" appears on the
digital display when there is
no video signal
English