Table of Contents
Advertisement
CABLE ANTENNA(CATV) CONNECTIONS (Cont'd)
75 ohm Cable System
2-way Splitter
(Not supplied)
CABLE CONVERTER
IN
AUDIO
IN
OUT
3
VIDEO
CH.
VCR's Back Panel
Note to CATV system installer (USA only): This reminder is provided to call the CATV
system installer's attention to Section 820-40 of the NEC which provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as practical.
VCR OUTPUT CHANNEL SETTING
VCR's BACK PANEL
ANT.IN
AUDIO
VHF/UHF
IN
OUT
/CATV
3
4
VIDEO
CH.
VCR OUTPUT CHANNEL SWITCH
This cable hookup allows you
either to view and record the
same channel (scrambled or
non-scrambled signal), or to
view one channel (non-scram-
bled signal) while recording
another channel (scrambled or
non-scrambled signal).
OUT
ANT.IN
VHF/UHF
/CATV
4
During playback of a video tape, and when press TV/VCR to set
the VCR mode, the VCR OUTPUT converter changes the video
and audio signals to the same type of signals that are used for
TV broadcasts. Set the VCR OUTPUT channel switch (marked
CH3, CH4 and located on the rear panel) to channel 3 or 4.
Select the channel that is not used for TV broadcasts in your
area.
This is your VCR OUTPUT channel. To play a tape, or to watch
TV using the VCR's built-in tuner, always set your TV's channel
selector to the same channel (3 or 4).
Cable/
Antenna
A/B Switch
(Not supplied)
75 ohm Coaxial
Cable (supplied)
TV set
9
Advertisement
Table of Contents
