Insignia NS-DCDCHH2 - Full HD Dual Camera Dash Cam Quick Start Guide

PACKAGE CONTENTS

• Dual Camera Dash Cam
• USB cable
• Vehicle power adapter
• Suction mount
• Quick Setup Guide

FEATURES

• 1080p resolution on front and rear-facing cameras
• G-force sensor automatically starts recording on impact
• Built-in microphone to capture audio
• Loop recording overwrites the oldest footage and prevents you from running out of storage

Refer to the online User Guide for more button information.

Before using your new product, please read these instructions to prevent any damage.

INSTALLING YOUR DASH CAM

Note: Use a card with 8 GB to 256 GB of memory. We recommend using a card with the highest memory capacity available. Higher memory capacity lets you record more.

1. Insert a microSD memory card (8 GB to 256 GB memory capacity).
   
2. Clean and thoroughly dry the windshield area where you want to mount your dash cam.
3. Insert and slide the mounting bracket on the suction cap into the mounting slot on the top of your dash cam.
4. Peel the protective film from the mounting bracket and the dash cam lens.
5. Position the suction cup on the windshield, then move the mounting bracket switch clockwise until you hear a click.
6. Connect the provided USB cable to the USB jack on your dash cam, then thread the cable from your dash cam, around the outer edge of the windshield, and to a 12V vehicle power socket.
7. Plug the cable into the vehicle power adapter, then plug the adapter into the power socket and turn on your vehicle. Your dash cam starts automatically.
   Note: The first time you insert a new SD card into your dash cam, the screen will prompt you with one of the following error messages if there is an issue with the card:
   • CARD ERROR Replace SD Card - indicates that the new card is not available to your dash cam (the card may be incompatible or damaged). Remove the SD card and replace it with another. Only SD cards between 8 and 256 GB should be used.
     OR
   • CARD ERROR FORMAT Card in Camera - indicates that the formatting on the new card is not compatible with your dash cam. Use the Format tool to format the card. This will delete all of the information on your dash cam, so please save your files first.
8. Rotate the mounting bracket to adjust the viewing angle as needed.

See your online User Guide for information about dash cam settings.

TURNING ON YOUR DASH CAM MANUALLY

1. Press and hold the power button to turn on your dash cam.
2. Press and hold the power button to turn off your dash cam.
   Note: If you have an SD card installed and if your dash cam is connected to a vehicle power socket, it starts recording automatically when you start your vehicle. You should review your first video to make sure that the camera is positioned correctly and that the video recorded correctly.

RECORDING VIDEO WITH YOUR DASH CAM

1. Make sure that your dash cam is turned on.
2. Press the OK button to begin recording.
3. Press the OK button again to stop recording.