How To Use - Beamz MegaCluster Laser RGB 600mW DMX IRC Instruction Manual

LASER SET UP & USAGE
This fixture has been designed to be hung. It is recommended for safety purposes, your lighting effect are properly mounted
using a suitable hanging clamp and safety cable. Items appropriate for safe and effective mounting are easily sourced from
your lighting vendor.
International laser safety regulations require that lasers must be operated in the fashion illustrated below, with a minimum of 3
meters (9.8ft) of vertical separation between the floor and the lowest laser light vertically. Additionally, 2.5 meters of horizontal
separation is required between laser light and audience or other public spaces.

HOW TO USE

DISPLAY
Using the four function buttons on the top of the unit you can set the operating mode of the laser. Press the MENU button to
display the different functions (see table below for a description of the functions).
Use the UP or DOWN arrow buttons to make your selection. When you have chosen your desired mode, press the ENTER
button to confirm the change.
Press MENU a little longer to run the latest saved mode or wait for 15 seconds to exit automatically and then run the latest
saved mode.
Mode Description
Adrr
DMX start address
SLnd NAST – Master unit
SLAU – Slave unit
Shnd Auto Mode
Sound Mode
SPEE Auto speed
LED
LED is on/LED is off automatically
dISP Display setting
FhrS Life time of the light
Vers Software version
DISPLAY MENU
This is changed using the UP or DOWN arrow buttons (1-512).
Press the ENTER button to confirm that this unit would be the
Master unit.
Press the ENTER button to confirm that this unit would be a
Slave unit.
Press the ENTER button and then use the UP or DOWN
buttons to choose Auto or Sound mode.
Adjustment from SP-1 to SP-9
If you choose the OFF option, the LED display will turn off after
20 seconds of inactivity. If you choose the ON option, the LED
display will remain permanently on.
The dIS option will show the LED display in a standard format.
dSIP will reverse the display.
Shows the total working time of the laser.
Indicates the current software version being used by the laser.
CAUTION: Use of controls,
adjustments, or
performance of
procedures other than
what is specified
herein may result in
hazardous radiation
exposure.
5