Connecting the DC Input
Connect the DC Input to the B-FP3D printer using the following procedure.
For how to check the charge status, please refer to the Owner's Manual of the
B-FP3D series Owner's Manual.
1. Make sure that the battery pack is in the printer.
2. Connect the plug of this device to the DCIN connector on the printer.
3. Fully insert the DC Input plug and the external power source symbol is displayed on the printer
LCD, and battery charge starts. Whether the battery charge is required or not is automatically
determined by the printer.
4. When the battery charge is completed, disconnect the device from the DC input and the printer.
NOTE:
Charging time may differ depending on the condition of the battery pack or the operating
temperature.
Jack Plug Adapter
B-FP3D Printer
6
DC Plug