Input Source Selection (S-Video, Component, Rgb Scart 21-Pin); Press The Point - Sanyo PLC-XW60 Owner's Manual

Video Input

Input Source Selection (S-video, Component, RGB Scart 21-pin)

Direct Operation
Choose S-video, Component or RGB(Scart) by pressing
the COMPUTER button on the remote control.
Before using COMPUTER button, correct input source
should be selected through Menu operation as described
below.
Note:
Input Search function is set to "Off".
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Press the Point
framed pointer to the Input Menu icon.
2

Press the Point

buttons to move the red arrow
pointer to Computer 1 and then press the SELECT
button.
3
After the Source Select Menu appeared for Computer
1, move the pointer to S-video, Component or RGB
(Scart) and then press the SELECT button.
When S-video input signal is connected
S-video
to the COMPUTER IN 1/S-VIDEO IN/
COMPONENT IN jack with a S-VIDEO-
VGA cable, select S-video.
W h e n t h e i n p u t s o u r c e i s c o m i n g
Component
f r o m v i d e o e q u i p m e n t c o n n e c t e d
t o t h e C O M P U T E R I N 1 / S - V I D E O
I N / C O M P O N E N T I N t e r m i n a l w i t h
a C o m p o n e n t - V G A C a b l e , s e l e c t
Component.
W h e n t h e i n p u t s o u r c e i s c o m i n g
RGB (Scart)
from video equipment connected to
t h e C O M P U T E R I N 1 / S - V I D E O I N /
COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
38
buttons to move the red
Remote Control
COMPUTER button
COMPUTER button
S-video
Computer 2
RGB(Scart)
Computer 2
See Notes at the bottom of this page.
Input Menu icon
Input Menu
M o v e t h e p o i n t e r ( r e d
arrow) to Computer 1 and
press the SELECT button.
Computer
1
Source Select Menu
S-video
M o v e t h e p o i n t e r t o
S-video, Component or
RGB (Scart) and press the
SELECT button.
Notes:
• W h e n t h e C O M P U T E R b u t t o n i s
pressed while the Input search function
is set to "On1" or "On2", the input
signal will be searched automatically
(p.46)
• When Monitor out is selected in the
Terminal function (p.50), Computer 2 is
not displayed.
Component
Computer 2