Axis P3265-LVE-3 User Manual page 15

AXIS P3265-LVE-3 License Plate Verifier Kit
Configure your device
Note
The Zipstream settings are used for both H.264 and H.265.
- Turn on Dynamic FPS.
- Turn on Dynamic GOP and set a high Upper limit GOP length value.
Note
Most web browsers don't support H.265 decoding and because of this the device doesn't support it in its web interface.
Instead you can use a video management system or application that supports H.265 decoding.
Set up network storage
To store recordings on the network, you need to set up your network storage.
1. Go to System > Storage.
2. Click
3. Type the IP address of the host server.
4. Type the name of the shared location on the host server under Network share.
5. Type the username and password.
6. Select the SMB version or leave it on Auto.
7. Select Add share even if connection fails if you experience temporary connection issues, or if the share is not yet
configured.
8. Click Add.
Record and watch video
Record video directly from the camera
1. Go to Video > Image.
2. To start a recording, click
If you haven't set up any storage, click
network storage on page 15
3. To stop recording, click
Watch video
1. Go to Recordings.
2. Click
Verify that no one has tampered with the video
With signed video, you can make sure that no one has tampered with the video recorded by the camera.
1. Go to Video > Stream > General and turn on Signed video.
Add network storage under Network storage.
.
again.
for your recording in the list.
and . For instructions on how to set up network storage, see Set up
15