Intex CLEARVIEW PRISM FRAME 126730GN Owner's Manual page 11

POOL SETUP (continued)
3. Vertical legs assembly
• Attach the leg's end cap (4) to the bottom of each leg (7) first. With
the beams and T-joints assembly resting on the ground, slide one
vertical leg into the belt loop located in the middle of the pool liner
and insert the top of the leg into the bottom of the T-joint (3) (see
drawing 6.1). Continue the process with all the vertical legs.
• Lift the beams assembly and make sure all the legs are in a vertical
position (see drawing 6.2). Push all the T-joints downward to ensure
they are firmly connected to the legs.
• Pull gently, in an outward direction, the bottom of the leg making sure
the leg is vertical and perpendicular to the level ground.
NOTE: Remove the clear view panel protective films from the inside
and outside of the pool before filling with water. If not removed
promptly, the protective films may adhere to clear view panel and
affect the level of clarity.
4. Filling of the pool
• If the pool was purchased without a filter pump, insert two of the three
plugs (10) into the black filter pump outlets. Do this from the inside of
the pool so that water will not run out when filling it. If the pool was purchased with a filter pump, read the
Krystal Clear™ Filter Pump Manual first and then proceed to next installation step.
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain
cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5 cm) of water. Check
to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting
up the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging
and a potential collapse of the pool. If the pool is not completely level, you must drain the pool,
level the area or move the pool to a different area that is level, and re-fill the pool, following the
above directions.
• Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool floor and pool
sides meet. Or, (from outside pool) reach under the side of the pool, grasp the pool floor and pull in
an outward direction. If the ground cloth is causing the wrinkles, have 2 people pull from opposite sides to
remove all wrinkles. Use the properly assembled pool ladder when entering or exiting the pool during this
process. Also make sure all the legs are vertical and perpendicular to the ground.
• Fill the pool with water up to just below the sleeve line but higher
than the clear view panel by 2 inches (5cm) (see
NOTE: For better performance, do not fill the water below the clear
view panel.
Important information regarding the clear view panel:
To ensure the best experience and lasting clarity of your clear view panel,
it is important to follow these general practices:
• Handle the clear view panel with extra care during unfolding of the liner and during installation to avoid
scratches, folds or kinks that can affect the clarity.
• Always maintain the water level above the clear view panel to avoid water line marks.
• Maintain clean and well balanced pool water quality – see "Pool Maintenance and Chemicals" section for
tips.
• Use only a clean, soft and damp towel to occasionally clean the clear view panel - never use harsh or
abrasive device or chemicals.
• When taking the pool liner down, follow the instructions on folding the liner and rolling the clear view panel.
NOTE: Over time, continuous exposure to sunlight may affect the level of clarity of your clear view panel.
This is normal.
SAVE THESE INSTRUCTIONS
(117IO) CLEARVIEW PRISM FRAME™ PREMIUM POOL ENGLISH 7.5" X 10.3" PANTONE 295U 12/14/2020
drawing
7
4
7).
Clear view panel
English
117A
6.1
3
6.2
7
4
7
Water lever
Page 10