Lamp Replacement - Sanyo PLC-XU07N Owner's Manual

Sanyo plc-xu07n: owners manual

Hide thumbs

Table Of Contents

Table of Contents

When the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow. When the

image become dark or the color of the image become unnatural, replacement of the Lamp is required.

CAUTION

For continued safety, replace with a lamp assembly of the same type.

Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector

can become very hot.

Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

Turn off the projector and disconnect the AC plug. Allow the

projector to cool for at least 45 minutes.

Remove a screw with a screwdriver and remove the lamp cover.

Remove 2 screws with a screwdriver and pull out the lamp

assembly by grasping the handle.

Replace the Lamp Assembly and tighten 2 screws. Make sure

that the Lamp Assembly is set properly. And replace the Lamp

Cover and tighten a screw.

Connect the AC Power Cord to the projector and turn the projector

on.

Reset the Lamp Replacement Monitor Timer (refer to the section

"Lamp Replacement Monitor Timer" below.)

NOTE : Do not reset the LAMP REPLACEMENT

MONITOR TIMER, when the lamp is not replaced.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following

information to the dealer.

Model No. of your projector

Replacement Lamp Type No. : POA-LMP19J

Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp

Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops to lighting.

Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINT

LEFT/RIGHT buttons to select SETTING

dialog box SETTING MENU Menu will appear.

Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to Lamp age, and then press the

SELECT button. The message of "Lamp replace monitor Reset?" is displayed.

Select [Yes] to reset the Timer.

Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.

LAMP REPLACEMENT Indicator