Raider Power Tools RD-F2 User Manual page 9

16. Turn off the fan and unplug it when not in use, when moving the fan from one
place to another and before cleaning.
17. To disconnect, grasp the plug and pull it out of the outlet. Never pull on the
cord.
18. Unplug and unplug when not in use before assembling or disassembling parts;
and before cleaning. To avoid tripping hazards, coil the cord securely.
19. Do not place this appliance on floors that may be marked or damaged by the
appliances vibration.
20. If the power cord is damaged, it must be replaced by the manufacturer, its ser-
vice agent or similarly qualified persons in order to avoid a hazard. Do not attempt
to repair, disassemble or modify the unit yourself. There are no user serviceable
parts inside.
ASSEMBLY INSTRUCTIONS
1. Remove the fan from the packaging.
2. Place the two mounting tubes over the mounting screws at both ends of the fan
body.
3. Place the mounting screws on the stand.
4. Tighten the outer nuts to the fan mount.
NOTE: When installing the control box, ensure that the cables are routed to the
outside of the base.
9