Table of Contents
Advertisement
ASSEMBLY AND INSTALLATION
BEFORE YOU GET STARTED
Spread cushioning flat to lay the TV on. This will help to prevent damage.
1. Stand assembly
a. Attach stands to base of TV, ensuring R and L stands are on correct side.
b. Insert two 20mm screws and use Phillips head screwdriver
(not supplied) to tighten.
1a
R
2. Connect to antenna
a. Connect an antenna cable (not supplied) via the 'ANT' input port at the
back of the TV.
b. Ensure the antenna cable is also connected to a working antenna, either
via an antenna wall socket in your home, or directly.
2a
HDMI 1
MI 4
HDMI 3
HDMI 2
ANT
(ARC)
1b
L
Antenna
wall socket
2b
DIGITAL
R -AUDIO- L
VIDEO
AUDIO OUT
AUDIO OUT
(5V / 500mA)
AV
3. Turning TV on
a. Plug the power cord into a suitable power outlet. The standby will display
a light, showing that the TV is receiving power.
b. Press the POWER ( ) button (either on your remote control or the lower
side of the back panel on the TV – see page 8) to turn the TV on. The
standby light will turn off when the TV is on.
TURNING TV OFF
Press the
To power down the TV completely, unplug the power cord from the power
outlet.
Do not leave your set in standby mode for long periods of time. If you will not
use the TV for a long time, it is recommended to unplug the set from both the
power outlet and aerial.
Antenna cable
(not supplied)
USB 2.0
POWER ( )
button on the remote control to enter standby mode.
Red light on
3a
Standby mode
Red light off
3b
TV on
6
Advertisement
Table of Contents
