Table of Contents
Advertisement
Water inlet
35°
Loosen the ring nut to angle the hose to the
left or right depending on the position of your
water tap. Do not place the inlet hose
downwards. After positioning the inlet hose,
be sure to tighten the ring nut again to prevent
leaks.
Water drainage
Firstly form a hook in the end of the drain hose
using the plastic hose guide supplied with the
appliance .
The end of the drain hose can be positioned
in four ways:
• Hooked over the edge of a sink using
the plastic hose guide.
www.zanussi.com
Connect the hose to
a tap with a 3/4"
thread.
45°
Tie the plastic hose guide to the tap with a
string to prevent that the drain hose unhooks
when the appliance is emptying.
• Onto a sink outlet spigot.
Push the drain hose onto the spigot and se-
cure with a clip, ensure a loop is formed in the
drain hose to prevent waste from the sink en-
tering the appliance.
If the outlet spigot has not been used before,
remove any blanking plug that may be in
place.
• Directly into a drain pipe at a height of
not less than 60 cm and not more than 100
cm.
The end of the drain
hose must always be
ventilated, i.e. the in-
side diameter of the
drain pipe must be
larger than the out-
side diameter of the
drain hose. The drain
hose must not be
kinked.
9
Advertisement
Table of Contents
