Table of Contents
Advertisement
to damage the RDC sensor. Be
8
sure to draw the attention of the
authorised BMW Motorrad dealer
130
or specialist workshop to the fact
that the wheel is fitted with an
RDC sensor.
Removing front wheel
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad rear-wheel
stand.
Install the rear-wheel stand
z
(
120).
with centre stand
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove screw 1 and remove
the wheel-speed sensor from
its bore.
Mask off the parts of the wheel
rim that could be scratched in
the process of removing the
OE
brake calipers.
ATTENTION
Unwanted inward movement
of the brake pads
Component damage on attempt
to install the brake caliper or be-
cause brake pads have to be
forced apart
Do not operate the brakes with
a brake caliper not correctly
secured.
Remove securing screws 2 of
the left and right brake calipers
and remove retaining clip 3.
Force the brake pads 1 slightly
apart by rotational movement
of the brake caliper 2 against
brake disc 3.
Carefully ease the brake cal-
ipers back and out until clear of
the brake discs.
Advertisement
Table of Contents
