Remote Control Buttons; Battery Replacement; Technical Notes - kobi SOLAR LED MHCS 10W Manual

Hide thumbs Also See for SOLAR LED MHCS 10W:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 3

REMOTE CONTROL bUTTONS

ON, lamp turns on,. ON/OFF switches on the remote control are
with memory function.
OFF, lamp flicks 3 times then turns off.
Auto, the lamp enters Auto Sensor Mode directly. Lamp brightness
and lighting time are not selectable under Auto Sensor Mode.
Keep Lighting Time
60% brightness
30% brightness
+15% brightness
by each press
(Max 60%)
-15% brightness by
each press
(Min 15%)
TWO OpTIONAL WORKING MODES :
Please press the button on the lamp first, the lamp will automatically turn on and
enter Auto Sensor Mode, and the remote control is activated at the same time.
Then, please use remote control to set desired working mode.
AUTO SENSOR MODE
Lamp automatically lights up at night and turns to full brightness when motion is
detected in the range <6m, then turns to lower brightness in 60 seconds of no motion.
When not fully charged, the lamp goes into energy saving mode, maintaining
brightness at 60% for maximum working time.
KEEp LIGHT MODE
Lamp automatically lights up at night and keep selected brightness for
3H/5H/8H, after which or when the battery power is less than 30%, lamp turns
to Auto Sensor Mode.

TECHNICAL NOTES:

1.
Please note that there is a very low risk of explosion of the battery due to its
Kobi-Light Sp. z o.o. Spółka Komandytowa ul. Boya-Żeleńskiego 2, 35-105 Rzeszów
These 7 keys (on grey background) are
only used to adjust lighting time and
brightness of Keep Lighting Mode. First
press the 3H/5H/8H and the lamp will
enter Keep Lighting Mode automatically,
then press
/
/
/
desired brightness.
For example:
Press
+
+
. Lamp lights up
at night and keeps 45% brightness for 5h.
After 5h or when battery power is less than
30%, lamp turns to Auto Sensor Mode.
lithium-ion design.
2.
The solar panel should be placed in a place where it absorbs a sufficient
amount of sunlight.
3.
Please note that the maximum lighting time of the LED luminaire will vary
depending on the absorption time and the intensity of the sun's rays.
4.
The luminaire is automatically turned on at dusk (unless it is turned off
remotely - using the appropriate button by the user).
5.
The recommended mounting height of the luminaire should be 3-5m higher
than the given reference point (e.g. 3m above the ground).
6.
The luminaire is equipped with an internal, replaceable battery. If it is necessary
to replace it, please contact the seller in order to select a suitable, new item.
7.
In order to start the luminaire after disconnecting and reconnecting the battery,
or to replace it, the solar panel should be directed towards the sunlight.
NOTES ON USE:
1.
It is forbidden to use a solar module other than the one originally attached
to set
to the luminaire. Any changes in this connection may result in injury and will
invalidate the product warranty.
2.
Remember to clean the motion sensor from time to time from dust and
sediment with a damp cloth.
3.
Periodic cleaning of the solar module shell is also recommended. A dirty cell
can reduce the photovoltaic performance.
4.
In both cases, in order to avoid discoloration on the casing, do not use strong
cleaning agents, e.g. those based on alcohol.

bATTERY REpLACEMENT:

Before replacing the battery, turn off the luminaire, making sure that the On/Off
button is in the Off position. Using the available tools, unscrew the bolts from the
battery casing and remove its cover. Remove the used battery, first disconnecting
it firmly from the power plug. The assembly of a new battery is carried out in a
similar manner to the disassembly.
UTILIZATION:
In accordance to European Directive 2012/19/EU regarding electrical
and electronic equipment, the WEEE with label such indicates label,
the under need of penalty separate of fine, collection can not of be
used thrown out into electrical ordinary and electronic garbage together
equipment. with Products other wastes. These products may be harmful to the
natural environment and human health, it requires a special form of treatment/
recovery / recycling/ disposal. You can find out about the utilization possibilities of
a warn out device in the appropriate city or commune office.
www.kobi.pl

Advertisement

Table of Contents
loading

Table of Contents