Table of Contents
Advertisement
Section 1: Introduction and Safety
Introduction
Thank you for purchasing a Generac Mobile product.
This unit has been designed to provide high-perfor-
mance, efficient operation, and years of quality use when
maintained properly.
The MIH800 indirect fired heater is designed and built for
sustained, reliable heat production in industrial operating
conditions and environments. The MIH800 is built to with-
stand frequent handling under these conditions.
The unit is mounted on a trailer that has forklift access
and chain attach points on both sides. The fully enclosed
design protects the operating components, allowing all-
weather storage and operations.
The information in this manual is accurate based on
products produced at the time of publication. The manu-
facturer reserves the right to make technical updates,
corrections, and product revisions at any time without
notice.
Read This Manual Thoroughly
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
If any section of the manual is not understood, contact
your nearest GMASD, or contact Generac Mobile Cus-
tomer Service at 800-926-9768, or visit
mobileproducts.com
with any questions or concerns.
The owner is responsible for proper maintenance and
safe use of the equipment. The manufacturer strongly
recommends that if the operator is also the owner, to
read the owner's manual and thoroughly understand all
instructions before using this equipment. The manufac-
turer also strongly recommends instructing other users to
properly start and operate the unit. This prepares them if
they need to operate the equipment in an emergency.
SAVE THESE INSTRUCTIONS for future reference. This
manual contains important instructions for the machine
that should be followed during installation, operation, and
maintenance of the heater and batteries. Always supply
this manual to any individual that will use this machine.
Intended Applications
The machine is designed for industrial use. Examples of
intended applications include, but are not limited to:
Gas and oil exploration
•
•
Utilities and power plants
•
Mining
Owner's Manual for Indirect Fired Heater
•
•
•
•
•
•
•
•
•
Using this machine for applications other than its
intended purpose may void the warranty. Examples of
misuse include, but are not limited to, using the machine:
•
•
•
•
•
•
Safety Rules
The manufacturer cannot anticipate every possible cir-
cumstance that might involve a hazard. The alerts in this
manual, and on tags and decals affixed to the unit, are
(000100a)
not all inclusive. If using a procedure, work method, or
operating technique that the manufacturer does not spe-
cifically recommend, verify that it is safe for others and
does not render the equipment unsafe.
www.generac-
Throughout this publication, and on tags and decals
affixed to the unit, DANGER, WARNING, CAUTION, and
NOTE blocks are used to alert personnel to special
instructions about a particular operation that may be haz-
ardous if performed incorrectly or carelessly. Observe
them carefully. Alert definitions are as follows:
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Construction
Agricultural applications
Employee locker areas and housing
Emergency thawing
Pre-warming of equipment and motors
Offshore drilling rigs
Painting and coating locations
Airline hanger heat
Dehumidification
To transport persons or equipment.
As a tow vehicle.
As a ladder or work surface.
During extreme weather.
Indoors.
If it is incorrectly serviced or maintained.
DANGER
WARNING
(000001)
(000002)
1
Advertisement
Table of Contents
