Table of Contents
Advertisement
Problem
Battery does not
power the computer
as long as expected
Real-Time Clock
Problem
The BIOS setting
and system date/
time are lost.
BIOS
Problem
The computer
cannot be powered
on
User's Manual
Procedure
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential. In these instances, you should fully
discharge the battery and then attempt to charge it
again.
Check the Power saver option under Creat a
power plan in the Power Options.
Procedure
The lasting time of the Real-Time Clock (RTC) has
run out. You must set the date and time in the
TOSHIBA Setup Utility by using the following
steps:
1.
Launch the TOSHIBA Setup Utility.
Refer to the
TOSHIBA Setup Utility
further information.
2.
Set the date in the System Date field.
3.
Set the time in the System Time field.
4.
Follow the on-screen instructions to proceed.
Procedure
Disconnect the AC adaptor for several seconds,
and reconnect the AC adaptor. After that, press the
power button.
If it does not work, press the power button twice
again.
If it still does not work, press and hold the power
button for 12 seconds.
Real-Time Clock (RTC) information might be
cleared if the power is turned on by pressing the
power button. You should set the system date/time
manually in TOSHIBA Setup Utility.
If it still does not operate properly, you should
contact your reseller or dealer.
section for
6-6
Advertisement
Table of Contents
