Record Voice To File - SanDisk Sansa m230 User Manual

Figure 5: The Recorder LCD screen
The control buttons and ports for your player are described in The Basic Controls section on
Page 3. More detailed descriptions on how the controls work is included in the step-by-step
instructions throughout this document. In addition, the Navigating the Software Menus
chapter on Page 25 describes the onscreen menus that appear when you use these controls.

Record voice to file

Once the Recorder screen appears, you can record to your voice. Follow these steps:
1. Press the Power/Menu Button once. The SanDisk logo will appear onscreen after a
moment then disappear. (Can't find the Power/Menu Button on your player? See
The Basic Controls section on page 3.)
2. Press the Power/Menu Button on the right side of your player. The software Menu
will appear. Use the Repeat/AB/Down Button to scroll and highlight Recorder
Modes. Press the Select Button to Recorder Modes
3. Press the Play/Pause/Up Button to start recording.
4. During the recording, If the Play/Pause/Down Button is pressed, the recording will
be pause, and if the Play/Pause/Down Button is pressed again, the recording will
be started again.
5. For stop recording, you have two choices:
Press the Repeat/AB/Down Button.
Press the Power/Menu Button.
6. For save file, you have two choices:
During the recording, if one press Repeat/AB/Down Button or Power/Menu
Button, the recording will be stopped and displayed the message of confirming
to save a file or not. Press Next/Fast Forward Button or Previous/Fast Reverse
Button, and press Select Button to save a file.
Press and hold down the Power/Menu Button until the "Powering Down"
message appears.
Voice recording
22