Table of Contents
Advertisement
Adjusting the
Motion-Control Levers
Adjusting the Height
You can adjust the motion-control levers higher or
lower for maximum comfort
Figure 21
Adjusting the Tilt
You can adjust the motion-control levers forward or
rearward for your comfort.
1.
Loosen the upper bolt holding the control lever
to the control-arm shaft.
2.
Loosen the lower bolt just enough to pivot the
control lever forward or rearward
3.
Tighten both bolts to secure the control lever in
the new position.
4.
Repeat the adjustment for the other control lever.
Pushing the Machine by
Hand
Important:
Always push the machine by hand. Do
not tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and
to push the machine, the ignition key needs to be in
the R
position. The battery needs to be charged
UN
and functioning for the electric brake to be disengage.
Pushing the Machine
1.
Park the machine on a level surface, and
disengage the blade-control switch.
2.
Move the motion-control levers outward to the
position, shut off the engine, and wait
PARK
(Figure
21).
g027252
(Figure
21).
for all moving parts to stop before leaving the
operating position.
3.
Locate the bypass levers on the frame on both
sides of the engine.
4.
Move the bypass levers forward through the
keyhole and down to lock them in place
22).
Note:
Do this for each lever.
5.
Move the motion-control levers inward to the
position and turn the ignition key to the
NEUTRAL
R
position.
UN
Note:
Do not start the machine.
Note:
You can now push the machine by hand.
1. Bypass-lever locations
2. Lever position for
operating the machine
6.
When finished, ensure that the key has been
returned to the S
the battery charge.
Note:
If the machine fails to move, the electric brake
may still be engaged. If necessary, the electric brake
can be released manually; refer to
Electric Brake (page
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
Note:
Do this for each lever.
26
Figure 22
3. Lever position for pushing
the machine
position to avoid draining
TOP
Releasing the
44).
(Figure
g017303
Figure
22.
Advertisement
Table of Contents
