Table of Contents
Advertisement
1.2
Notes on radio frequency
This product complies with local radio frequency regulations in the country or region where
you purchased the product. Note that it cannot be used in any areas other than the country
or region of its purchase.
In the frequency band used by this product, not only industrial, scientific and medical
equipment such as microwave ovens but also premises radio stations (license required)
and specified low-power radio stations (license not required) for mobile object
identification such as used in factory manufacturing lines, etc., and amateur radio stations
(license required) may be in operation. Use of this product may cause radio interference
with the above equipment and radio stations, so be sure to understand the following
precautions before use.
• Before using this product, make sure that there are no premises radio stations and
specified low-power radio stations for mobile object identification operating nearby.
• In the event that radio waves from this product cause harmful interference to premises
radio stations for mobile object identification, immediately stop using the product and
contact your sales representative or local Canon dealers.
• Also contact your sales representative or local Canon dealers if other problems occur,
such as harmful radio interference from this product to specified low-power radio
stations for mobile object identification or amateur radio stations.
• This product may be affected by radio interference from other devices that generate
radio waves (microwave ovens, Bluetooth devices, digital cordless phones, etc.). Keep
the product as far away from those devices as possible to avoid radio interference during
use.
• This product is suitable for use in hospital (professional healthcare facility) environments,
with the exception of environments near active HF SURGICAL EQUIPMENT or the RF
shielded room of an ME SYSTEM for magnetic resonance imaging, where the intensity
of ELECTROMAGNETIC DISTURBANCES is high.
• WARNING:
Use of this equipment adjacent to or stacked with other equipment should be avoided
because it could result in improper operation. If such use is necessary, this equipment
and the other equipment should be observed to verify that they are operating normally.
• To maintain the optimum EMD performance, use only the designated cables.
• WARNING:
Use of equipment, transducers and cables other than those specified or provided by
Canon sales representative or local Canon dealer could result in increased
electromagnetic emissions or decreased electromagnetic immunity of this equipment
and result in improper operation.
• WARNING:
Portable RF communications equipment (including peripherals such as antenna cables
and external antennas) should be used no closer than 30 cm (12 inches) to any part of
the detector, including cables specified by Canon sales representative or local Canon
dealer. Otherwise, degradation of the performance of this equipment could result.
1
Safety information
9
Advertisement
Table of Contents
