Table of Contents
Advertisement
3
3.1
System startup
Preparing to use the detector
3.2
12
Operating procedures
Preparations
1
Switch on the image-capture computer on which the control
software is installed.
2
Confirm that the control software starts and the initial
settings screen is displayed on the monitor.
1
Attach a fully charged battery pack to the detector.
2
Press the POWER switch of the detector to turn it on.
3
Connect the detector to the image-capture computer.
Conducting examination
1
Enter the required items in the control software, such as the
Patient ID and target body part.
2
After confirming that the ready indication is displayed on the
monitor of the image-capture computer, press the exposure
switch of the X-ray generator to irradiate the patient with X-
rays.
Advertisement
Table of Contents
