Protecting A Recorded Cassette; Recording A Programme Immediately - Samsung SV-640B Instruction Manual

01299A SV-643B/XEU-GB2 9/3/56 7:16 AM Page 22
NICAM
GB
USER SET
O K E N D: M E N U
O S D : O N
TAPE SELECT : E 1 8 0
COLOUR SYSTEM :AUTO
FORMAT 16:9 :AUTO
NICAM :ON
ECO. MODE :OFF
IPC :ON
E N D: M E N U
22
NICAM programmes are divided into 3 types. NICAM Stereo,
NICAM Mono and Bilingual (transmission in another language).
NICAM programmes are always accompanied by a standard mono
sound broadcast and you can select the desired sound.
Please refer to page 32.
1
Press MENU on the remote control.
Result: The programming menu is displayed.
2
Press the corresponding , or , buttons to select the
USER SET option.
3
Press the OK button to select this option.
Result: The USER SET menu is displayed.
4 Press the corresponding or buttons, until the
is selected.
5
To... Press or , until...
Mono mode O F F is displayed.
OFF: Only set at this position to record the
standard mono sound during a
NICAM broadcast if the stereo sound
is distorted due to inferior reception
conditions.
NICAM mode O N is displayed.
ON: Normally set at this position.
6
On completion, press MENU twice to exit the menu.

Protecting a Recorded Cassette

Video cassettes have a safety tab to prevent accidental erasure.
When this tab has been removed, you cannot record on the tape.
1 If you wish to protect a cassette, break off the tab using a small
screwdriver.
2
To re-record over a protected cassette (safety tab broken), cover
the hole with adhesive tape.

Recording a Programme Immediately

N I C A M option
Before recording a programme, you must have preset the corres-
ponding station (unless you are recording via an external video
source). If you have not done so, refer to pages 17 and 18.
1
Switch on the television.
2 To monitor the programme being recorded, select the television
channel reserved for use with your VCR (or the AV input if used).
3
Insert the cassette on which the programme is to be recorded,
with the window visible and the safety tab intact or the opening
covered with adhesive tape.
Result: The VCR is switched on automatically.
4
Select:
The station to be recorded using the PROG(
or
The AV1, AV2 or AUX (SV-645B only) source using the
INPUT button for a satellite tuner or external video source
Result: The station number is displayed and the programme
can be seen on the television.
5
Select the recording speed by pressing the SPEED button as
many times as required (see page 21).
6 Hold REC down for a while to start recording.
Result: The record indicator appears on the television and VCR
display. An index is recorded on the tape (see page 35).
7 To stop recording, press
If your VCR ejects the cassette when you start
recording, check to make sure that the cassette's
safety tab is intact or that the opening (created by a
broken safety tab) is covered with adhesive tape.
If you reach the end of the tape while recording, the
cassette rewinds automatically.
or ) buttons
once.
GB
1
4
4
5
7
6
23