Table of Contents
Advertisement
2.
Remove the dipstick. Wipe clean and install fully into the dipstick tube. Wait 60 seconds to allow trapped air to vent.
a
3.
Remove the dipstick and observe the oil level. Oil level must be in the operating range. Install the dipstick into the dipstick
tube.
Filling
IMPORTANT: Do not overfill the engine with oil.
IMPORTANT: Always use the dipstick to determine the exact quantity of oil required.
1.
Remove oil fill cap.
2.
Add the specified engine oil to bring the level up to, but not over, the operating range mark on the dipstick. Check the oil
level.
3.
Replace the fill cap.
All Models
Engine oil (with filter)
Engine Oil and Filter
Replace the oil filter at every oil change.
See Maintenance Schedule for the change interval. Engine oil should be changed before placing the boat in storage.
IMPORTANT: Change engine oil when the engine is warm from operation. Warm oil flows more freely, carrying away more
impurities. Use only recommended engine oil (refer to the Specifications section).
90-8M0128976
MAY 2017
eng
a
Capacity
6.5 Liter (7 US qt)
a -
Oil dipstick handle
b -
Operating range
50315
a -
Oil fill cap
50316
Mercury 25W‑40 Synthetic Blend 4‑Stroke
Section 4 - Maintenance
Fluid Type
Engine Oil
Page 49
Advertisement
Table of Contents
