Table of Contents
Advertisement
4.5 IPMI
Use this feature to configure Intelligent Platform Management Interface (IPMI) settings.
When you select this submenu and press the <Enter> key, the following information will
display:
•
BMC Firmware Revision: This feature indicates the firmware revisionof the BMC (Base-
board Management Controller) used in your system.
•
IPMI STATUS: This feature indicates the status of IPMI used in your system.
System Event Log
Enabling/Disabling Options
SEL Components
Select Enabled to enable all system event logging upon system boot. The options are Enabled
and Disabled.
Erasing Settings
Erase SEL
Select "Yes, On next reset" to erase all system event logs upon next system boot. Select
"Yes, On every reset" to erase all system event logs upon each system reboot. Select "No"
to keep all system event logs after each system reboot. The options are "No", "Yes, On next
reset", and "Yes, On every reset".
When SEL is Full
This feature allows the user to determine what the BIOS should do when the system event
log is full. Select Erase Immediately to erase all events in the log when the system event log
is full. The options are Do Nothing and Erase Immediately.
123
Chapter 4: UEFI BIOS
Advertisement
Table of Contents
