Installation - Rohl San Julio G7545 Manual

PREPERATION FOR INSTALLATION
Unlike other household hot water appliances, this electronic instant hot water appliance is
Non Pressurised for safety reasons. For this electronic instant hot water appliance, the
Instant Hot Dispenser is placed before the electronic instant hot water appliance, creating
an "open vent" system and consequently no pressure is built up inside the appliance.
IMPORTANT: Install the Instant Hot Water Dispenser in accordance with
the fitting Instructions provided with the Hot Water Dispenser.
Preparation for the electronic instant hot water appliance installation
IMPORTANT: Observe all local governing codes and ordinances.
The electronic instant hot water appliance must be mounted vertically and level.
Before you begin, select a proper location ideally directly under the instant hot water Dis-
penser or close to it to ensure the connection pipes will connect from the instant hot wa-
ter Dispenser to the electronic instant hot water appliance.
The electronic instant hot water appliance is not under pressure, consequently, there is a
slight delay in water flow after the hot water springback Dispenser handle has been turned
on. This is normal and indicates that the electronic instant hot water appliance is function-
ing properly.
It is recommended that you have access to a separate power circuit serving only your elec-
tronic instant hot water appliance. See previous pages for more information on
"ELECTRICAL REQUIREMENTS".
Step 1– Position the Instant Hot Water Appliance
Ensure the electronic instant hot water appliance is NOT connected to the Electric Power
during installation.
Place the electronic instant hot water appliance in position and check to ensure that the
instant hot water Dispenser connection pipes and the power cord will reach without being
stretched.
The electronic instant hot water appliance must be positioned so the tubes from and to
the instant hot water Dispenser do not twist or kink.

INSTALLATION